CR-V Installation Guide: 
Side Step Bar


difficulty ~
time ~ 1.5 hours
The Package includes 6 sets of nuts for each side step bar.  A total of 12 sets of nuts for left and right side.
Step 1: Remove Snap-on Screws to Locate the screw holds.

Remove all snap-on screws located at the side bottom of the car.    (There are more snap-on screws than the picture illustrated.)
After removing all snap-on screws. Slightly lift the plastic protector to located the screw holds for later installation.  (We use tape to marks the screw holds for later drilling purpose.)
Step 2: Marking and drilling the holds

We have carefully align the screw holds and mark it.  After marking it, we use a electric driller to drill the holds.
Step 3: Installing the Side Step Bar

Lastly, secure the side step bar with nuts as shown in the picture.